What Actually Happens At The Atomic Level When A Knife Cuts Something?

Table of Contents (click to expand)

A knife never slips between atoms: even a fresh razor's edge is rounded to about 40 nanometers, a few hundred atoms across, so it pushes on chemical bonds, not gaps. Cutting piles force onto a tiny area until the bonds at one point break, and the sharp tip of the crack that starts there collects the stress, so the next bonds in line break one after another, like a zipper opening. Sliding the blade as you push halves the force you need, which is why sliding through a tomato beats pushing, and why a hair fifty times softer than steel can still chip a razor by loading it from the side. Splitting an atom means dividing its nucleus, a job for a neutron absorbed inside a reactor or a particle accelerator, not a blade.

Ask a room of people how a knife cuts and most will draw the same picture. The blade is so thin that it slips between the atoms, and the two halves fall apart. A tidy picture, and the one most people carry.

It is also wrong, because a knife edge is a few hundred atoms wide at best. There is no gap for it to find.

So what does the edge do instead? It pushes on chemical bonds until they break, and it does so in a clever order. That order explains why sharp beats blunt, why sliding beats pushing, and why a hair can chip a steel razor.

Are We Technically Touching Anything?

An atom is mostly empty space. We measured how empty in an earlier article. The nucleus holds nearly all the mass, yet it is around 100,000 times smaller across than the atom.

The rest is the electron cloud, and a cloud has no hard rim. An atom's electrons behave as a spread-out wave, and two such waves can and often do overlap, which is why "do atoms touch?" has no one-word answer.

When two clouds overlap and share electrons, the atoms are held together, and that link is a chemical bond. Pulling one apart takes real energy, and the link is short. The carbon-to-carbon bonds in a tomato's cell walls are about 0.15 nanometers long, and a nanometer is a millionth of a millimeter.

Cutting a solid means breaking some of those bonds along a line, and nothing else.

An atom's electrons form a cloud with no hard rim. These are the shapes the single electron of a hydrogen atom can take. (Photo Credit: PoorLeno, Wikimedia Commons, public domain)
An atom's electrons form a cloud with no hard rim. These are the shapes the single electron of a hydrogen atom can take. (Photo Credit: PoorLeno, Wikimedia Commons, public domain)

Does A Knife Really Slide Between Atoms?

Two numbers settle it. The first is the gap, about one bond length, that 0.15 nanometers.

The second number is the blade. The sharpest everyday edge is a razor blade, which is honed until its tip is rounded to a radius of about 40 nanometers. That is the typical figure the MIT team behind a 2020 study of how hair dulls razors gives for a blade edge. Measured in bonds, that makes the whole edge roughly 500 atoms wide.

A kitchen knife is far blunter than that. Materials scientists put the start of "sharp" at an edge radius of a few micrometers, and a micrometer is a thousand nanometers. So a sharp kitchen edge is tens of thousands of atoms wide. Next to a 0.15-nanometer gap, it is a freight train trying to fit through a letterbox.

The edge never goes between anything. It sits on top of thousands of atoms at once and pushes.

From the length of a bond to the thickness of a hair, on a scale where each step is ten times bigger. The razor tip, the sharpest thing in the house, is still hundreds of atoms out.
From the length of a bond to the thickness of a hair, on a scale where each step is ten times bigger. The razor tip, the sharpest thing in the house, is still hundreds of atoms out.

Why Does A Sharp Knife Cut Better Than A Blunt One?

The school answer is pressure, and it is right as far as it goes. Pressure is the force you push with divided by the area that push is spread over:

P = F ÷ A

Shrink the area and the pressure climbs. That is how a needle turns an ordinary push into one that breaks skin. A sharp knife edge meets the food along a strip about a thousandth of a millimeter wide. Let that edge wear five times wider, and the same push gives one-fifth the pressure, so the food squashes instead of splitting. Engineers use force-over-area inside a solid too, where they call it stress, and that is the word from here on.

Pressure says why sharp beats blunt, not how a cut starts or why it keeps going. For that, zip up a jacket, then open it. You do not rip all the teeth apart at once. The slider parts them one pair at a time, and each pair needs only a small tug. A cut works like that. The stress under the edge only has to break the bonds at one point, and after that, the point does the work.

An engineer named Inglis worked out why a century ago, by studying a plate with a long oval hole in it. The stress was highest at the two ends of the oval, and it grew as the hole got longer and thinner. A crack is a long, thin oval, so its tip is where the stress piles up. Take a nick a tenth of a millimeter deep with a tip as sharp as a fresh razor, and the bonds at that tip feel about a hundred times the stress of the bonds a millimeter away. They are the ones that break.

Griffith added the energy accounting in the 1920s. A crack can only grow if there is enough stored energy to pay for the new surface it creates. Every broken bond makes a little new surface, and the energy in the squeezed material pays for it. As long as the blade feeds stress to the tip, the tip keeps moving.

That is the whole mechanism. The knife starts a crack under its edge, then rides the crack tip through the food, breaking bonds one row at a time.

One nick, 0.1 mm deep. Sharpen its tip and the stress at that point climbs from three times the background to a hundred times.
One nick, 0.1 mm deep. Sharpen its tip and the stress at that point climbs from three times the background to a hundred times.

Why Does Sliding The Blade Cut Better Than Pushing?

Push a knife straight down on a tomato and the skin dents. Slide it back an inch as you push and the skin parts. However sharp the knife, cutting is easier with a slide added to the push, and an engineer who spent a career on cutting gave the effect a number: the slice–push ratio, how far the blade slides along its edge divided by how far it pushes in.

The rule that comes out is simple. Slide as far as you push and the push you need halves. Slide three times as far as you push and it falls to a tenth. The blade is not cheating: the work of breaking the bonds does not change. Sliding spreads that work over a longer path and loads the crack tip in a kinder direction. Teeth on the blade have nothing to do with it.

This physics has a darker side. A tongue cut on an envelope flap comes from the same effect. The envelope is not sharp. Your tongue slid along it.

It also explains why a soft tomato is so hard to cut. Soft things move out of the way. A crack needs stress at its tip, and a floppy material spends the push on stretching and denting instead. The skin dips, the flesh squashes, and the first bonds never see the stress they need. The fix is a light push and a long slide. Bread is the same problem with air added: a tough crust over a crumb that collapses, a stiff shell resting on a cushion.

The push you need falls fast as the blade slides. At a slice–push ratio of 3, a tenth of the force does the job.
The push you need falls fast as the blade slides. At a slice–push ratio of 3, a tenth of the force does the job.

Why Do Razor Blades Go Dull If Hair Is 50 Times Softer Than Steel?

Now for the paradox everyone has met at the bathroom sink. Razor steel is about fifty times harder than the outer layer of a human hair. Yet a razor loses its edge after a few shaves. A hair, which is not known for its toughness, wins.

The team that measured the 40-nanometer edge also watched a blade cut single hairs inside the electron microscope. The edge barely rounded. Instead, chips formed along certain stretches of it.

The chips did not appear at random. When the blade cut straight down through a hair, nothing chipped. Tilt the blade, as it is tilted in a real shave, and the hair bends and pushes one side of the edge. The chips appeared where the edges of the hair had been, one from each side.

The last ingredient is the steel itself. Fine steel is a patchwork of grains and hard particles, some bigger than the edge is. Where a hair's edge lands on a weak patch at an angle, a microcrack starts and a chip comes off. All of that has to line up at once, which is why a blade survives several shaves before it fails. A blade dies from sideways loads.

Sharpening is the reverse. A dull edge has rounded, so the stress at the crack it starts has dropped, or it has chipped. Sharpening grinds the two faces of the wedge back until they meet in a fresh, tight edge. Every stroke on a stone removes steel; nothing is "realigned." There is a catch. An edge a few hundred atoms wide is also an edge a bent hair can chip. Sharpness and fragility are the same property seen from two sides.

A safety-razor blade. Its edge is rounded to about 40 nanometers, and a bent hair can chip pieces off it. (Photo Credit: András Bögöly, Wikimedia Commons, CC BY 2.0)
A safety-razor blade. Its edge is rounded to about 40 nanometers, and a bent hair can chip pieces off it. (Photo Credit: András Bögöly, Wikimedia Commons, CC BY 2.0)

Could A Knife Ever Split An Atom?

If the edge breaks bonds, could it go one step further and split an atom itself? That depends on what "splitting an atom" means, since it can mean two very different things.

Knocking an electron loose from an atom's outer cloud is called ionization. It costs between a few and a couple of dozen electron volts, the same currency as a chemical bond, and the atom survives it with its nucleus untouched. Dividing the nucleus itself is nuclear fission, and when physicists say an atom was split, this is what they mean.

Two things keep a blade out of that business. One is size: the nucleus is around a hundred thousand times smaller across than its atom, so an atom at the knife's edge never comes anywhere near the nucleus of an atom in the tomato; the electron clouds meet and repel long before. The other problem is energy, and it is worse. The protons and neutrons in a nucleus hold together with millions of electron volts each, about a million times the price of a bond, while a blade sliding through a tomato gives each atom at its edge less than a millionth of an electron volt of motion.

So how does an atom actually get split? In a reactor, by a slow neutron that gets inside the nucleus: it carries no electric charge, so nothing in the atom repels it, and when a uranium-235 nucleus absorbs one, it breaks into two lighter nuclei, throws out fresh neutrons, and releases some two hundred million electron volts, more than fifty million times the energy of the bond a knife breaks. The neutron brings almost no energy of its own; the nucleus had it stored all along. The other route is a particle accelerator, a machine that drives charged particles into a nucleus by brute force; the first one split that way, in 1932, was lithium, struck by protons and broken into two helium nuclei. A knife only pushes on the outside of thousands of atoms at once, and the chance of it splitting one is, for every practical purpose, zero.

How an atom is really split: a slow neutron is absorbed by a uranium-235 nucleus, which breaks into barium and krypton and throws out three fresh neutrons. (Photo Credit: MikeRun, Wikimedia Commons, CC BY-SA 4.0)
How an atom is really split: a slow neutron is absorbed by a uranium-235 nucleus, which breaks into barium and krypton and throws out three fresh neutrons. (Photo Credit: MikeRun, Wikimedia Commons, CC BY-SA 4.0)

So, What Actually Happens At The Atomic Level When A Knife Cuts Something?

Put the pieces together. The edge, a few hundred atoms wide at best, lands on top of thousands of atoms and pushes. Force over that tiny area drives the stress under the edge past what the bonds there can take, and the first few break. That makes a crack with a tip. Inglis' geometry piles the stress onto the tip, so the next bonds in line break next, and Griffith's energy balance keeps the tip moving as long as the blade feeds it. The zipper opens.

Nothing in that story goes between atoms, and nothing splits one, a gap no sharper edge can close. We covered the paper version in are you splitting atoms when you tear paper, and the answer for a knife is the same. The atoms are pushed apart, whole and unharmed.

A knife is a machine for breaking bonds a row at a time. The whole art of sharpness is getting the first row to break with the least effort. Watch the skin of the next tomato you cut. It dents, and then, the moment you slide the blade back, it parts.

A plain blade cuts bread perfectly well, as long as it slides. (Photo Credit: Steppeland, Wikimedia Commons, CC BY 4.0)
A plain blade cuts bread perfectly well, as long as it slides. (Photo Credit: Steppeland, Wikimedia Commons, CC BY 4.0)
References (click to expand)
  1. How hair deforms steel — Roscioli, Taheri-Mousavi & Tasan, Science 369, 689–694 (2020)
  2. Why shaving dulls even the sharpest of razors — MIT News, 6 August 2020
  3. Slice–push, formation of grooves and the scale effect in cutting — A. G. Atkins, Interface Focus 6, 20160019 (2016), PMC4843631
  4. 11.3 Pressure — College Physics 2e, OpenStax
  5. Cracking Dams: History of fracture mechanics (Inglis 1913, Griffith 1920s) — Sethna group, Cornell University
  6. Can Objects Touch? — Ask the Van, University of Illinois Physics
  7. Bond Lengths and Energies — UCLA Molecular Biology Institute lecture notes
  8. 12.2.4 Sharpness — H. Föll, Iron, Steel and Swords, University of Kiel
  9. Nuclear Binding Energy — HyperPhysics, Georgia State University
  10. Nuclear Size and Density — HyperPhysics, Georgia State University
  11. Ionization Energies — HyperPhysics, Georgia State University
  12. Bond Energies — Chemistry LibreTexts
  13. Nuclear Fission and Uranium-235 Fission — HyperPhysics, Georgia State University
  14. Energy From Uranium Fission — HyperPhysics, Georgia State University
  15. Fission and Fusion: What is the Difference? — U.S. Department of Energy, Office of Nuclear Energy
  16. Rutherford's Nuclear World: Atop the Physics Wave (Cockcroft and Walton split the lithium nucleus, 1932) — AIP History Center