Table of Contents (click to expand)
A heat pump does not make heat, it carries heat from a cooler place to a warmer one, and the steeper that climb, the less heat it delivers for each unit of electricity. Warming a house is a short climb, so a good heat pump delivers three to four units of heat per unit of electricity, but searing a steak is a climb about seven times steeper, and the delivery falls to roughly one unit, which a plain electric coil already gives you far more cheaply. No working fluid used in heat pumps even stays usable at frying temperatures, so a heat pump stove would cost more, cook slower, and save nothing.
Open your fridge. That gentle hum you have ignored your whole life is a heat pump, and it is very good at its job.
Walk around the house and you will find more. Heat pumps now warm rooms, heat water, and dry clothes, and a heat pump clothes dryer uses around 70% less energy than a conventional one.
Then you reach the stove, and the streak ends. Every stove either burns gas or pushes electricity through a coil until it glows. Nobody sells a heat pump stove, and not because engineers forgot. Cooking asks a heat pump to do the one thing it is worst at.
What Does A Heat Pump Actually Do?
Your refrigerator does not make cold. It picks up heat from inside the cabinet and drops it out the back, which is why the coils behind it are warm. An air conditioner does the same trick pointed outdoors, and run in reverse in winter it heats your home. That is all a domestic heat pump is. The stove is the odd one out, sitting there burning things.

A gas flame and an electric coil make heat, the way rubbing your hands together makes heat out of movement. A heat pump makes no heat at all. It carries heat that already exists somewhere else to where you want it, and even cold winter air holds plenty, because it sits a long way above the true bottom of the temperature scale.
The carrying is done by a liquid called the working fluid (you may know it as refrigerant). It soaks up heat at the cold end and boils into a gas, a compressor squeezes that gas and makes it hot, and the gas gives up its heat at the hot end indoors and turns back into a liquid. Hold on to that word, carries. A heat pump is a delivery service, not a factory, and its fee depends on how far uphill it has to carry the heat.
We measure the result with COP, short for coefficient of performance: for every unit of electricity you feed in, how many units of heat come out? A typical home heat pump scores between three and four. That sounds like it breaks physics, but the first law of thermodynamics survives, because two of those three units were already outside in the cold air. The electricity only paid for the carrying.

What Is The Biggest Disadvantage Of A Heat Pump?
Not cost, noise, or lifespan. It is the climb: the temperature gap between where the heat pump picks heat up and where it drops it off. Engineers call it the lift.
COP is not a rating stamped on the machine at the factory. It is a property of the climb. That is why the air from a heat pump vent can feel lukewarm while the room warms perfectly well: the machine delivers heat at the lowest temperature that will do the job, because hotter air costs it COP.
It is also why a heat pump struggles as the outdoor air gets colder, and why heating a home costs more than cooling one: that is the climb growing from the bottom. Cooking attacks it from the top, and the top is far more brutal.
There is a hard ceiling on how good any heat pump can be, and it depends only on those two temperatures:
COP ceiling = Thot ÷ (Thot − Tcold)
Thot is the temperature you deliver heat at, Tcold is where you collect it from, and both must be in kelvin: Celsius with 273 added, so that zero sits at the coldest temperature possible. Use Celsius and the arithmetic produces nonsense, including a cheerful divide-by-zero on a freezing day.
Let us run a house. The heat pump delivers 35 °C air, and it is 0 °C outside.
- Convert: Thot = 35 + 273 = 308 K, and Tcold = 0 + 273 = 273 K
- The climb: 308 − 273 = 35 K
- The ceiling: 308 ÷ 35 = almost 9
Real hardware never reaches its ceiling. It lands somewhere between 40% and 60% of the way there, which puts our house between three and five, right around the three-to-four quoted for domestic units. And notice where the climb sits: on the bottom of the fraction. Make it bigger and the whole thing shrinks.
What Happens When You Point A Heat Pump At A Frying Pan?
Searing a steak needs a pan surface up around 235 °C (455 °F). The heat pump, meanwhile, stands in a room-temperature kitchen, and to pull heat out of that room its cold end has to sit below it, at roughly 5 °C.
Same equation. New numbers.
- Convert: Thot = 235 + 273 = 508 K, and Tcold = 5 + 273 = 278 K
- The climb: 508 − 278 = 230 K, about seven times the house
- The ceiling: 508 ÷ 230 = 2.2
The ceiling has collapsed to a quarter of the house figure. Apply the same reality check and a real machine delivers somewhere between 0.9 and 1.3.
Sit with that. A plain electric coil has a COP of exactly 1: one unit in, one unit out, no moving parts, about twelve dollars. At cooking temperatures the heat pump lands on top of it and stops being an advantage. You would have bought a compressor, two heat exchangers and a lifetime of servicing in exchange for roughly nothing.
Even gentle browning is a stretch. The browning that makes food taste good only gets going above about 120 °C. Aim for 160 °C instead of a sear and the ceiling is still below three, so a real machine manages between one and two. Better than a coil, technically, but not enough to justify a compressor in your countertop.

Why Can't Refrigerants Get Hot Enough To Cook?
Suppose you did not care about efficiency and just wanted the thing to work. You still could not build it. There is a second wall.
A heat pump drops off its heat when the hot working fluid condenses back into a liquid. That change of state is where the energy comes out. But every fluid has a critical temperature, above which it refuses to be a liquid no matter how hard you squeeze it. Above that point there is no condensing, and the delivery mechanism is simply gone.
Those temperatures are not high. Line up the working fluids engineers use and the best gives up a little above 170 °C; carbon dioxide quits at a frankly unhelpful 31 °C. You cannot even use the last stretch, because the fluid has to condense about 15 K below its critical point to run efficiently, which leaves the best mainstream fluids near 156 °C. That is below good browning, and nowhere near a sear.
Water has a gloriously high critical temperature, but at kitchen temperatures its vapor is so thin that you would need a compressor the size of the kitchen.

Industry Has 200 °C Heat Pumps, So Why Not A Heat Pump Stove?
Industrial heat pumps do reach cooking temperatures, at a respectable COP. One recent installation delivers steam at 195 °C, hot enough to sear anything you like, and measured a COP of 2.3. So the hardware exists. Why can it not go under your stove?
Look at where that machine starts. It draws its heat from hot water at about 70 °C, waste heat the factory was throwing away anyway. Run the same three steps and the climb is 125 K, not the 230 K your kitchen imposes, so the ceiling comes out a little under four. The project runs at 61% of its ceiling, which is exactly the measured figure.
That is the punchline. Those machines are not winning on clever engineering. They are winning because a factory hands them heat that is already warm, so they have half as far to climb. A stove starts at room temperature every single time, and climbs beyond 80 K are already where industrial heat pumps begin to struggle. Cooking asks for nearly three times that.
Even if you ignored the physics, cooking is a high-power, fast-response job: serious heat in the pan within seconds, and gone just as fast when the sauce threatens to split. A compressor and two heat exchangers cannot do fast. And a heat pump stove pulls its heat out of the room it stands in, so cooking a Sunday roast would air condition your own kitchen. Useful in Brisbane in January. An act of hostility in Manitoba.
So, Why Are There No Heat Pump Stoves?
Because a heat pump's advantage was never a property of the machine. It was always a property of the climb.
Most of us think of a heat pump as an efficient device, the way an LED bulb is an efficient bulb. It is not. Its efficiency is set by the job you hand it. Give it an easy climb and it looks miraculous. Give it a hard one and it becomes an expensive kettle.
Heat pumps conquered the rest of your home because those jobs are all short climbs. A fridge, a warm room, a load of laundry, a tank of hot water: none of them asks for more than about 60 °C, and on a short climb the physics pays you three or four times over. Cooking demands a climb of more than 200 K, and the same equation that makes heat pumps brilliant at the easy jobs makes them pointless at this one.
So what won at the stove instead? Induction, and not by beating the physics. An induction stove has a COP of essentially 1, exactly like an electric coil. What it does instead is stop wasting the heat it makes, by making that heat inside the pan rather than under it. With gas cooking, only around a third of the heat reaches your food, while induction is up to three times as efficient as gas. Once that is the ceiling, "heat the pan, not the room" is the only lever left, and induction pulls it hard.

So the next time you sear a steak and the pan roars, look around. This is the one corner of your house where the second law refuses to give you a discount. Everywhere else, it quietly hands you three units of heat for the price of one.

References (click to expand)
- Heat Pumps and Coefficient of Performance — HyperPhysics, Georgia State University
- Annex 58: High-Temperature Heat Pumps, Task 1 Technologies Task Report — IEA Heat Pumping Technologies
- Large Temperature Lifts: A Major Challenge? The Future of Industrial Process Heat — HPT Magazine, Vol. 43 No. 3, 2025
- Maillard Reaction in Flour Product Processing — PMC, National Library of Medicine
- Air Source Heat Pump Operating Tips — NYSERDA, New York State
- Clothes Dryers — ENERGY STAR, US Environmental Protection Agency
- 5 Reasons to Switch from Gas to ENERGY STAR Certified Electric Cooking — ENERGY STAR
- Making the Switch to Induction Stoves or Cooktops — US Department of Energy
- Defining an Industrial Heat Pump: A Review and Synthesis — Energy Conversion and Management: X, 2025 (OSTI.GOV)







